Hi,
I have a serious connection problem with a TXT 3 contoller running 4.6.6.
Normal situation is that I use ssh to login to the controller via Wifi using 2 ssh terminals. All worked fine, until there was an power problem. Power loss happened many times before, and the solution always was to start the controller again, wait for the ssh broken pipe message (only takes a few minutes) and login again.
Now, the broken pipe message appears after a very long time and only in 1 terminal. Not good. So I try to login and it does not connect all. After some error seeking, I find out that on the controller in Network, wlan0 and netmask are empty. Checking for my other TXT controller: not empty and I can login just fine.
So I decide to edit the IP address and find that all the correct data is still there. Nothing for me to do. But it doesn't show anymore in the wlan0 display.
I decide to re-enter all wlan0 data, but this doesn't solve the problem. Still no IP data in wlan0 display and no connection. Also not after several reboots of the controller.
Is there any way I can solve this? RoboPro only connects to the controller via Wifi. Since version 4.6.6 no more via USB.
Thanks for any help.
I have a serious connection problem with a TXT 3 contoller running 4.6.6.
Normal situation is that I use ssh to login to the controller via Wifi using 2 ssh terminals. All worked fine, until there was an power problem. Power loss happened many times before, and the solution always was to start the controller again, wait for the ssh broken pipe message (only takes a few minutes) and login again.
Now, the broken pipe message appears after a very long time and only in 1 terminal. Not good. So I try to login and it does not connect all. After some error seeking, I find out that on the controller in Network, wlan0 and netmask are empty. Checking for my other TXT controller: not empty and I can login just fine.
So I decide to edit the IP address and find that all the correct data is still there. Nothing for me to do. But it doesn't show anymore in the wlan0 display.
I decide to re-enter all wlan0 data, but this doesn't solve the problem. Still no IP data in wlan0 display and no connection. Also not after several reboots of the controller.
Is there any way I can solve this? RoboPro only connects to the controller via Wifi. Since version 4.6.6 no more via USB.
Thanks for any help.
Statistik: Verfasst von hvn — 09 Apr 2025, 11:22
